New wood glued and shored in place around the carver heater. The old stuff was all rotten.
Subscribe to:
Post Comments (Atom)
skip to main |
skip to sidebar
statcounter
Followers
Blog Archive
-
▼
2009
(27)
-
▼
September
(26)
- Light and roof rail sealing
- http://www.nocounciltax.com/
- Living in while repairing, Bin Laden did my van
- Avondale Landranger 6400 damp repair
- No title
- All of the wood which is black was saturated with ...
- All clamped to the outer skin with Pinkgrip again,...
- These clamps were ideal in all window areas, no ne...
- New wood in place and shored up, the smaller lengt...
- The first two sections of new wood in place on the...
- New wood glued and shored in place around the carv...
- Angle bracket and light cluster surround from abov...
- Easier than those woodworking joints and a stronge...
- This is after my first cut attempt was too big to ...
- New boarding going in place. The wood showing in t...
- Angle grinder with Aldi sanding disk attached, rea...
- More sanding required
- Feathered in the wood filler with the angle grinde...
- No title
- I started at the back centre, working outwards to ...
- No title
- Side unit complete with curtains, light to be adde...
- The rear has gone back in fine, only the bunk ligh...
- Curtains were left fitted to the shelving units to...
- No title
- All done, everything back together and the only mo...
-
▼
September
(26)
No comments:
Post a Comment